Cell Culture Information

Cell Culture Information for HuH-7

HuH-7 Cells should be cultured in DMEM supplemented with 10% FBS. Cells should be grown at 37 °C in a 5% CO2 setting.

Subculture Protocol for HuH-7

To subculture:

Renew medium 2-3 times a week, or as needed according to media pH, and maintain cell confluency between 30-90%. Do not allow cell concentration to exceed 90% confluency, otherwise cells will decrease proliferation rates.  The doubling time of HuH-7 cells is 24 hours.

Cells can also be subcultured by centrifuging and resuspending in fresh medium:

  1. Rinse cells with trypsin-EDTA to remove media containing FBS.
  2. Add just enough trypsin-EDTA to cover the bottom of the flask and observe for cell detachment under a microscope.  Detachment should occur within 2-15 minutes. Do not agitate cells during this process in order to avoid clustering of cells. If cells do not detach, place flask in incubator for to facilitate dispersal.
  3. Neutralize trypsin-EDTA by adding media containing FBS at 4x the volume of trypsin-EDTA added; centrifuge the cells and remove the supernatant.
  4. Add 10 mL of growth medium to the pellet and aspirate with gentle pipetting to resuspend cells.
  5. Split cells: Add an aliquot of the cell suspension to a new culture vessel at the appropriate split ratio.
  6. Return flask to 37°C with 5% CO2.

To cryopreserve HuH-7 cells

After cell collection, the cells can be frozen in growth medium supplemented with 10% (v/v) DMSO following slow freeze methods.  Long term storage of HuH-7 cells includes storage in the liquid nitrogen vapor phase.

Troubleshooting Subculture Procedures

Cells are difficult to detach from flask:

  • Cells were too confluent; cell-to-cell junctions are extremely tight, thus preventing dissociation agents from reaching cell interface; resolve by maintaining cells at sub-confluent levels
  • Dissociation agent is weak, use a higher concentration; incubate the flask containing the dissociation agent at 37°C to increase enzymatic activity
  • Ensure the flask was washed completely with 1x PBS before the addition of dissociation agent; if necessary, perform two 1x PBS washes

My cell viability is low after I passage cells:

  • Reduce harsh pipetting during cell collection
  • Only leave dissociation agent on cells long enough so that cells detach; cells may have been exposed to the dissociation agent for too long

Cells form clumps after detachment:

  • Cells were centrifuged too hard; only spin cells at 100 x g for 5 minutes
  • Place the flask or vial on ice to decrease cell aggregation if cells are not used immediately

Tips

  • Confluency: Cells in flasks must be grown in an environment that falls within a certain range of confluency. Too few cells will stop growing due to lack of cell-to-cell contact and too many cells will cause the cells to stop proliferating due to lack of room. Flask confluency should be maintained between 30-90%.
  • Passage Number: Cells undergo genetic drift with high passage number.  Passage numbers should not allowed to reach high numbers that result in slow growing cells and hard to transfect cells.
  • Thawed Aliquot: Thawed cells are fragile and should be thawed in less than 1 minute. Do not pellet the cells with centrifugation to remove freezing media.  Rather, the DMSO will be diluted to a low enough concentration by adding the thawed aliquot directly to a flask containing warm media.

Links

Stable Cell Line Generation Services

List of Companies Offering Lab Services

Purchase HuH-7 cells: JCRB0403 [HuH-7]